HP ProCurve 6400cl Series - RIP Parameters and Defaults; RIP Global Parameters

IP Routing Features
Configuring RIP
RIP Parameters and Defaults
The following tables list the RIP parameters, their default values, and where
to find configuration information.
RIP Global Parameters
11-3 lists the global RIP parameters and their default values.
Table 11-3. RIP Global Parameters
Parameter Description Default
RIP state Routing Information Protocol V2-only. Disabled
auto-summary Enable/Disable advertisement of summarized routes. Enabled
metric Default metric for imported routes. 1
redistribution RIP can redistribute static and connected routes. (RIP Disabled
redistributes connected routes by default, when RIP is
enabled.)
RIP Interface Parameters
11-4 lists the VLAN interface RIP parameters and their default values.
Note RIP interface configuration is performed on VLAN interfaces in the switches
covered by this manual.
Table 11-4. RIP Interface Parameters
Parameter Description Default
RIP version The version of the protocol that is supported on the
interface.
The version can be one of the following:
• Version 1 only
• Version 2 only
• Version 1 compatible with version 2
metric A numeric cost the routing switch adds to RIP routes
learned on the interface. This parameter applies only
to RIP routes.
V2-only
1
11-22