Table 56 Contents of the Copy Group Attributes Panel (continued)
When effectiveCopy typeDescriptionItem
When the YKSUSPND
command is executed
BC
CA
CAA
CAJ
Specify the write-protect mode for
the S-VOL (required).
For BC, PERMIT is the default. For
CA and TCA, PROTECT is the
default.
• PROTECT: Update of the S-VOL
is prohibited after a copy pair is
suspended (YKSUSPND
command is executed).
• PERMIT: Update of the S-VOL is
allowed after a copy pair is
suspended (YKSUSPND
command is executed).
PROT MODE
When the YKQUERY
command is executed
CAJSpecify the consistency time mode
to be used when the copy type is
CAJ.
• JOURNAL: Uses the consistency
time committed to the restore
journal.
• VOLUME: Uses the consistency
time committed to the S-VOL.
• ASIS: Uses the consistency time
set according to the storage
system setting.
C/T TIME MODE
When the YKMAKE
command is executed
When the YKRESYNC
command is executed
CASpecify whether to transfer the
writing timestamp to the S-VOL
when the copy type is CA
(timestamp transfer mode).
• Y: Transfers the timestamp to the
S-VOL. Specify this item only
when you are using the CAJ
ATTIME suspend function in a
4x4x4 Cascade configuration
or a 3DC Cascade
configuration.
• N: Does not transfer the
timestamp to the S-VOL.
TIMESTAMP
• When the YKMAKE
command is executed
• When the YKRESYNC
command is executed
(with OPENMFUPDATE
specified)
CASpecify whether the Open/MF
Consistency Preservation Function
is to be used when the copy type is
CA.
Y: Uses the Open/MF Consistency
Preservation Function (Open/MF
Consistency attribute setting).
N: Does not use the Open/MF
Consistency Preservation Function.
OPEN/MF
84 ISPF Panels
To Next Page
Loading...
