357
Configuration procedure
In the server configuration, the client's host public key is required. Use the client software to generate
RSA key pairs on the client before configuring the Stelnet server.
There are different types of Stelnet client software, such as PuTTY and OpenSSH. This example
uses an Stelnet client that runs PuTTY version 0.58.
The configuration procedure is as follows:
1. Generate RSA key pairs on the Stelnet client:
a. Run PuTTYGen.exe on the client, select SSH-2 RSA and click Generate.
Figure 98 Generating a key pair on the client
a. Continue moving the mouse during the key generating process, but do not place the mouse
over the green progress bar shown in Figure 99. Otherwise, the progress bar stops moving
and the key pair generating progress stops.
To Next Page
Loading...
