Huawei AR1200 Series - Checking the Configuration; Maintaining DSVPN; Displaying the DSVPN Configuration; Clearing DSVPN Statistics

The tunnel interface is bound to an IPSec profile.
----End
6.3.7 Checking the Configuration
After DSVPN is configured, you can view NHRP mapping entries and IPSec profile
configuration.
Prerequisites
All DSVPN configurations are complete.
Procedure
l Run the display nhrp peer command to check NHRP mapping entries.
l Run the display ipsec profile [ brief | name profile-name ] command to check the IPSec
profile configuration.
----End
6.4 Maintaining DSVPN
This section describes how to display the DSVPN configuration and clear DSVPN statistics.
6.4.1 Displaying the DSVPN Configuration
You can run the display commands to check NHRP mapping entries and NHRP packet statistics.
Prerequisites
All DSVPN configurations are complete.
Procedure
l Run the display nhrp peer command to check NHRP mapping entries.
l Run the display nhrp statistics interface interface-type interface-number command to
check NHRP packet statistics.
----End
6.4.2 Clearing DSVPN Statistics
This section describes how to clear NHRP packet statistics.
Context
CAUTION
Statistics cannot be restored after being cleared. Exercise caution when you run the reset
command.
Huawei AR1200 Series Enterprise Routers
Configuration Guide - VPN 6 DSVPN Configuration
Issue 01 (2012-04-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
352