EasyManua.ls Logo

Huawei AR1200 Series - Configuring the VTY User Interface

Huawei AR1200 Series
392 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Context
Do as follows on the MCE.
You need to perform similar configurations on a PE. For details, refer to manuals of
corresponding products.
Procedure
Step 1 Run the system-view command to enter the system view.
Step 2 Run the rip [ process-id ] vpn-instance vpn-instance-name command to create and enable a
RIP process used by a VPN instance and enter the RIP view.
Step 3 Run the network network-address command to enable RIP routes on the network segment where
the IP address of the interface bound to the VPN instance belongs.
Step 4 (Optional) Run the import-route { { static | direct } | { { rip | ospf | isis } [ process-id ] } }
[ cost cost | route-policy route-policy-name ]
*
command to import routes from other routing
protocols.
If another routing protocol is run between an MCE and a site in this VPN, you need to perform
this step.
----End
2.4.4 (Optional) Configuring OSPF Between an MCE and a PE
Context
Do as follows on the MCE.
You need to perform similar configurations on a PE. For details, refer to manuals of
corresponding products.
Procedure
Step 1 Run the system-view command to enter the system view.
Step 2 Run the ospf [ process-id | router-id router-id | vpn-instance vpn-instance-name ]
*
command
to create an OSPF process used by a VPN instance and enter the OSPF view.
NOTE
In this step, you must specify vpn-instance vpn-instance-name.
Step 3 (Optional) Run the import-route { limit limit-number | protocol [ process-id ] [ cost cost |
route-policy route-policy-name | tag tag | type type ]
*
} command to import routes from other
routing protocols.
If another routing protocol is run between an MCE and a site in this VPN, you need to perform
this step.
Step 4 Run the area area-id command to create an OSPF area and enter the OSPF area view.
Step 5 Run the network address wildcard-mask [ description text ] command to enable OSPF routes
on the network segment where the IP address of the interface bound to the VPN instance belongs.
----End
Huawei AR1200 Series Enterprise Routers
Configuration Guide - VPN 2 MCE Configuration
Issue 01 (2012-04-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
52

Table of Contents

Other manuals for Huawei AR1200 Series

Related product manuals