Huawei AR1200 Series - Configuring the Console User Interface

The interface is bound to the VPN instance.
NOTE
The running of the ip binding vpn-instance command on an interface can delete the Layer 3 attributes,
such as the IP address and routing protocol. If these Layer 3 attributes are still required, you need to
configure them again.
Step 4 Run:
ip address ip-address { mask | mask-length }
The IP address is configured.
----End
2.2.4 Checking the Configuration
Run the command display ip vpn-instance [ verbose ] [ vpn-instance-name ] to check the
previous configuration.
If the configuration is correct, you can view:
l VPN instance created correctly
l Name of the VPN instance
l RD
l Description
l Maximum number of routes supported by the VPN instance
l Interface configured correctly
<Quidway> display ip vpn-instance verbose
Total VPN-Instances configured : 1
VPN-Instance Name and ID : vpn1, 1
Create date : 2011/09/10 16:58:42
Up time : 0 days, 21 hours, 42 minutes and 10 seconds
Log Interval : 5
2.3 Configuring a Route Multi-Instance Between an MCE
and a Site
This section describes how to configure static routes, RIP, OSPF, IS-IS, and BGP between an
MCE and a site.
For configuring a route multi-instance between an MCE and a site,2.3.2 (Optional) Configuring
a Static Route Between an MCE and a Site to (Optional) Configuring BGP Between an MCE
and a Site are optional and can be configured as required.
2.3.1 Establishing the Configuration Task
Applicable Environment
To connect a CE to multiple VPNs and isolate services of these VPNs, you need to configure
MCE functions. Before configuring MCE functions, you need to perform the task of 2.2
Configuring a VPN Instance on the MCE and PE and then configure a route multi-instance
between an MCE and a site.
Huawei AR1200 Series Enterprise Routers
Configuration Guide - VPN 2 MCE Configuration
Issue 01 (2012-04-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
46