Huawei AR1200 Series - Optional) Configuring IS-IS between an MCE and a Site; Checking the Configuration

To Next Page

To Previous Page

NOTE

In this step, you must specify vpn-instance vpn-instance-name.

Step 3 (Optional) Run the import-route { limit limit-number | protocol [ process-id ] [ cost cost |

route-policy route-policy-name | tag tag | type type ]

} command to import routes from other

routing protocols.

If another routing protocol is run between an MCE and a PE in this VPN, you need to perform

this step.

Step 4 Run the area area-id command to create an OSPF area and enter the OSPF area view.

Step 5 Run the network address wildcard-mask [ description text ] command to enable OSPF routes

on the network segment where the IP address of the interface bound to the VPN instance belongs.

----End

2.3.5 (Optional) Configuring IS-IS Between an MCE and a Site

Context

Do as follows on the MCE.

You need to configure only routing protocols on a device in a site.

Procedure

Step 1 Run the system-view command to enter the system view.

Step 2 Run the interface interface-type interface-number command to enter the view of the interface

bound to the VPN instance.

Step 3 Run the isis enable [ process-id ] command to enable IS-IS on the interface.

By default, IS-IS is disabled on a VLANIF interface.

Step 4 Run the isis [ process-id ] vpn-instance vpn-instance-name command to create an IS-IS process

used by a VPN instance and enter the IS-IS view.

Step 5 Run the network-entity net command to configure an NET.

By default, no NET is configured for an IS-IS process.

Step 6 Run the import-route protocol [ process-id ] [ cost-type { external | internal } | cost cost |

tag tag | route-policy route-policy-name | [ level-1 | level-2 | level-1-2 ] ]

command to import

routes from other routing protocols.

If another routing protocol is run between an MCE and a PE in this VPN, you need to perform

this step.

----End

2.3.6 Checking the Configuration

Run the display ip vpn-instance [ verbose ] [ vpn-instance-name ] command on the MCE. If

you can view the route to the local VPN in the display, it means that the configuration succeeds.

Take RIP used between an MCE and a site as an example. The information is displayed as

follows:

Huawei AR1200 Series Enterprise Routers

Configuration Guide - VPN 2 MCE Configuration

Issue 01 (2012-04-20) Huawei Proprietary and Confidential

Other manuals for Huawei AR1200 Series