Settings Procedure
Enable TLS 1.1 and TLS 1.2.
NOTE
You must enable TLS 1.1 and TLS 1.2
when the HTTPS protocol is used to
access the camera. Otherwise, the
camera WebUI cannot be opened.
1. Choose Tools > Internet
Options.
The Internet Options dialog box
is displayed.
2. Click the Advanced tab.
3. Select Use TLS 1.1 and Use TLS
1.2.
4. Click OK.
Set Use Pop-up Blocker to Disable. 1. Choose Tools > Internet
Options.
The Internet Options dialog box
is displayed.
2. Click the Security tab.
3. Select Internet.
4. Click Custom level.
The Security Settings-Internet
Zone dialog box is displayed.
5. Set Use Pop-up Blocker to
Disable.
6. Click OK.
Step 2 Commission cameras and set parameters for them. For details, see the delivered
documents.
1. Preview the site situation in real time and check the camera coverage through
videos. Adjust the lens if necessary.
2. On the View tab page, click the Network/Time tab to access the Network/
Time tab page.
FusionModule2000-S Smart Modular Data Center
User Manual 5 Power-On Commissioning
Issue 07 (2022-09-30) Copyright © Huawei Technologies Co., Ltd. 211
To Next Page
Loading...
Need help?
General