Huawei FusionModule800 User Manual

Name, Specications, and Appearance
Pipe bender Insulation gloves Pressure gauge (1
PCS)
a
Rubber hose (3
PCS)
a
Nitrogen
b
Reducing valve
c
Vacuum pump
d
Water pipe thread
sealant
e
a. Pressure gauge and rubber hose: dedicated for R410A. The measuring range
of the pressure gauges must be at least 4.0 MPa, and the rubber hoses must
withstand a pressure of at least 4.5 MPa. Ensure that the rubber pipes match
the 1/4 inch needle valves inside the unit. If necessary, prepare needle valve
adapters.
b. Dry nitrogen.
c. Nitrogen reducing valve: A reducing valve must be installed on the head of
the nitrogen cylinder, and the reducing valve range must be at least 4.0 MPa.
d. Vacuum pump
airow: 2–4 L/s; absolute vacuum: ≤ 60 Pa.
e. For equipment with humidiers, ensure that the water pipe thread sealant
can resist temperatures higher than 85°C and the following requirements are
met:
● Applicable to all pipe materials
● Anaerobic metal pipe thread sealant with PTEF as the padding
● Maximum gap: 0.5 mm
● Pressure resistance: above 1.6 MPa
● Compliant with the industry standard JB∕T7311-2008
Technical Specication
for the Application of Anaerobic Glue in Engineering Machinery
4.1.2 Personnel Requirements
Only trained and qualied personnel who fully understand basic safety
precautions are allowed to install and operate a modular data center.
FusionModule800 Smart Small Data Center
User Manual 4 Installation Guide
Issue 01 (2021-02-05) Copyright © Huawei Technologies Co., Ltd. 94

Huawei FusionModule800 Specifications

General

Brand	Huawei
Model	FusionModule800
Category	Storage
Language	English