Huawei FusionModule800 User Manual

6.4.4.12 Replacing a Temperature Sensor
Prerequisites
● Recommended tools and materials: diagonal pliers, insulation tape, cable tie,
step ladder (2 m)
● A temperature sensor needs to be replaced.
● Spare temperature sensors of the same model are available and functional.
Procedure
Step 1 Cut the cable ties on the temperature sensor using diagonal pliers, and remove
the network cable from the temperature sensor.
Figure 6-63 Removing a temperature sensor
Step 2 Install the spare temperature sensor, bind it to the original position using cable
ties, and connect cables to it.
FusionModule800 Smart Small Data Center
User Manual 6 O&M
Issue 01 (2021-02-05) Copyright © Huawei Technologies Co., Ltd. 472

Huawei FusionModule800 Specifications

General

Model	FusionModule800
Form Factor	Modular
Power Supply	Dual Hot-swappable Power Supplies
Cooling System	In-row cooling or room-level cooling
Power Density	High Power Density
Deployment Time	Less than 1 week
Energy Efficiency	High Energy Efficiency
Humidity Range	5% to 90% (non-condensing)
Altitude	Up to 3000 meters