● Video Type: Select the video type based on the customer's device.
● Link: Enter the external IP address of the camera (for example, https://
external IP address of the camera
).
● Change IP camera ONVIF interface access password: The default password
of ONVIF is HuaWei123, which is dierent from the web user password. If
you have changed the default password for accessing the ONVIF interface of
the IP camera, enter the new password in Password. Otherwise, the ECC800-
Pro cannot collect motion detection alarms from the IP camera.
Figure 5-37 Adding video information
Figure 5-38 Password for accessing the IP camera ONVIF interface
Step 4 After entering the video information, click Conrm.
Step 5 In the Video Information list, click the link under the Link column and go to the
camera WebUI as prompted.
Step 6 For details about how to commission the camera and set parameters, see the
documents delivered with the device or the documents obtained by referring to
the "Preparing Documentation" section.
1. Preview the site situation in real time and check the camera coverage through
videos. Adjust the lens if necessary.
2. (Optional)
Congure an SD card if the VCN or IVS1800 is not congured.
FusionModule800 Smart Small Data Center
User Manual 5 Power-On Commissioning
Issue 01 (2021-02-05) Copyright © Huawei Technologies Co., Ltd. 309
To Next Page
Loading...
Need help?
General