Currently, the VCN and NTP source server must be in the same LAN for NTP
synchronization. For details, see Step 2.
If the VCN and the NTP source server are not in the same LAN, you need to manually
set the time as follows: Choose Local
Conguration > Server conguration and
change Timezone cong and Time cong based on the time of the source server to
be synchronized.
5. Choose Maintenance > Unied Conguration, set Module Name to MU,
and click Search.
6. (Skip this step for a device that is not VCN510-16P.) In the search result, click
Edit in the row where Parameter Name is NatRtspServerPort, delete the
parameter value 0 from Value, leave the value empty, and click Save.
Figure 5-51 Setting the NAT port number for the MU
7. In the search result, click Edit in the row where the value of Parameter Name
is NatIP and set Value to the external IP address of the VCN. Click Save.
Figure 5-52 Setting the external IP address of the MU
Set NatIP to the external IP address of the VCN, which is the same as the external IP
address mapped by the VCN on the ECC800-Pro.
8. Set Module name to OMU and click Search.
9. In the search result, click Edit in the row where Parameter Name is
OMUNatIP and set Value to the NAT IP address of the MU. Click Save.
FusionModule800 Smart Small Data Center
User Manual 5 Power-On Commissioning
Issue 01 (2021-02-05) Copyright © Huawei Technologies Co., Ltd. 318
To Next Page
Loading...
Need help?
General