Huawei FusionModule800 User Manual

Indicator Color Name Status Description
RF_Z Green Communication
status indicator
Blinking at
long
intervals
A network is set up, and no
node access is allowed (the
indicator blinks at 0.5 Hz, on
for 1s and then o for 1s).
Blinking at
super
short
intervals
A network is set up, and
node access is allowed (the
indicator blinks at 10 Hz, on
for 0.05s and then o for
0.05s).
SW Button
Table 3-29 SW button description
Function
Description
Operation Description Indicator Status
Wireless
network RF_Z
(802.15.4)
pairing
In non-wireless network (802.15.4)
pairing mode, press and hold down
the button for 3s to 5s to enter the
wireless network pairing mode.
The RF_Z indicator is
blinking at super
short intervals.
In wireless network (802.15.4)
pairing mode, press and hold down
the button for 3s to 5s to exit the
pairing mode; or the system
automatically exits the pairing mode
after 30 minutes without pressing
the button.
The RF_Z indicator is
blinking at long
intervals.
Press and hold down the button for
more than 8s to clear network
parameters.
The RF_Z indicator is
steady on.
WLAN enabling Press the button for less than 3s to
enable WLAN.
None
Restoring the
default IP
address, factory
settings, and
user information
Press and hold down the button for
1 minute.
None
FusionModule800 Smart Small Data Center
User Manual 3 System Architecture
Issue 01 (2021-02-05) Copyright © Huawei Technologies Co., Ltd. 55

Huawei FusionModule800 Specifications

General

Brand	Huawei
Model	FusionModule800
Category	Storage
Language	English