Huawei FusionModule800 User Manual

4.3.5.1.3 Connecting Input Power Cables to the Converged Cabinet...................................................................... 227
4.3.5.1.4 Connecting Output Power Cables to the Converged Cabinet.................................................................. 228
4.3.5.2 Bottom Cable Routing............................................................................................................................................... 230
4.3.5.3 Connecting PDU2000 Power Cables..................................................................................................................... 232
4.3.5.4 Connecting Signal Cables for the Intelligent PDU2000..................................................................................234
4.3.5.5 Preparing Power Cables.............................................................................................................................................237
4.3.5.6 Connecting Cables Between the Battery and the UPS................................................................................... 237
4.3.6 Management System Cable Connection................................................................................................................. 238
4.3.6.1 Connecting Cabinet Electronic Clasp Lock Cables............................................................................................238
4.3.6.2 Connecting a Monitoring Cable to the Smart ETH Gateway....................................................................... 239
4.3.6.3 Connecting IVS Cables............................................................................................................................................... 240
4.3.6.4 Connecting a Cable to the WLDS900 Water Sensor....................................................................................... 241
4.3.6.5 (Optional) Connecting Cables for the In-Room Access Control System.................................................. 242
4.3.6.6 (Optional) Connecting Cables to the ATS Subrack..........................................................................................244
4.4 Verifying the Installation................................................................................................................................................. 245
5 Power-On Commissioning................................................................................................. 250
5.1 Power-On Commissioning for the Power Supply and Distribution System................................................... 250
5.1.1 UPS Power-On Commissioning.................................................................................................................................. 251
5.1.1.1 Checking Before Power-On...................................................................................................................................... 251
5.1.1.2 Single UPS Operations............................................................................................................................................... 251
5.1.1.2.1 Starting a UPS Using Mains Power....................................................................................................................251
5.1.1.2.2 Shutting Down a UPS............................................................................................................................................. 253
5.1.1.2.3 Performing EPO........................................................................................................................................................ 253
5.1.1.3 Parallel System Operations...................................................................................................................................... 254
5.1.1.3.1 Starting the UPSs Using Mains Power.............................................................................................................. 254
5.1.1.3.2 Shutting Down a Parallel System....................................................................................................................... 255
5.1.1.3.3 Performing EPO........................................................................................................................................................ 257
5.1.2 Connecting the Lithium Battery Supply.................................................................................................................. 257
5.2 Power-On Commissioning for the Cooling System.................................................................................................257
5.2.1 Powering on Devices...................................................................................................................................................... 257
5.2.2 Performing Initial
Conguration................................................................................................................................258
5.2.2.1 Setting Temperature and Humidity.......................................................................................................................258
5.2.2.2 Setting Teamwork Control Parameters................................................................................................................ 259
5.2.2.3 Setting the Maximum Outdoor Fan Speed.........................................................................................................262
5.2.3 Commissioning the Cooling System......................................................................................................................... 262
5.3 Management System Power-On Commissioning....................................................................................................267
5.3.1 Preparations and WebUI Login.................................................................................................................................. 267
5.3.2 Preparations and App Login........................................................................................................................................ 271
5.3.3 Initial Startup Password Authentication................................................................................................................. 273
5.3.4 How Can I Set the Date and Time?.......................................................................................................................... 275
5.3.5 Adding a Southbound Device..................................................................................................................................... 276
5.3.6 Creating a Smart Module Plan View........................................................................................................................ 276
FusionModule800 Smart Small Data Center
User Manual Contents
Issue 01 (2021-02-05) Copyright © Huawei Technologies Co., Ltd. viii

Huawei FusionModule800 Specifications

General

Brand	Huawei
Model	FusionModule800
Category	Storage
Language	English