Huawei N2000H V3 - 7.28 DIMM Removal

N2000H V3 Appliance
User Guide
7 Replacing Parts
Issue 04 (2018-11-06)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
197
9. Lower the securing rod near the or label. See step (4) in Figure 5-54.
10. Align the heat sink with the fastening studs on the CPU socket, and place the heat sink
on the CPU. See step (1) in Figure 5-56.
Figure 5-56 shows the heat sink direction.
Figure 7-56 Installing a heat sink
11. Use a Phillips screwdriver to tighten the four screws on the heat sink in the diagonal
direction. See step (2) in Figure 5-56.
----End
7.28 Removing a DIMM
This topic describes how to remove a dual in-line memory module (DIMM) before replacing
it with a new one.
Scenarios
Remove a DIMM in any of the following scenarios:

A DIMM fails.

A DIMM is to be replaced with a new model.
Prerequisites
Conditions

You have powered off the N2000H V3. For details, see 3.2 Powering Off.