Huawei N2000H V3 User Manual

N2000H V3 Appliance
User Guide
4 Configuring the N2000H V3
Issue 04 (2018-11-06)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
68
Table 4-2 describes the procedures for configuring the Appliance.
Table 4-2 Procedures for configuring the Appliance
Procedure
Description
Checking the Appliance

Check that the board versions are the required ones.

Check for alarms about the Appliance.
Configuring RAID properties
The N2000H V3 supports the LSISAS2308,
LSISAS3008, and LSISAS3108 controller cards.
Configure RAID properties for the Appliance based on
actual site requirements.
Configuring the basic
input/output system (BIOS)
Configure the Appliance BIOS, including the boot mode,
network drive, preboot execution environment (PXE)
options of the network interface card (NIC), and BIOS
password.
Changing the user password
for iBMC
Change the default password for the iBMC.
Installing an operating system
(OS)
For details, see HUAWEI Appliance OS Installation
Guide.
4.2 Checking the N2000H V3
This topic describes how to check the N2000H V3 initial status.
Scenarios
Log in to the iBMC WebUI or CLI to check the health status of the N2000H V3. Ensure that
its health status meets the environment requirements for software installation.
Prerequisites
Conditions
The N2000H V3 is powered on.
Data

You have obtained the user names and passwords for logging in to the N2000H V3
iBMC WebUI or CLI.

You have obtained the IP address for the N2000H V3 iBMC management network port.
Table 4-3 Default information
Item
Parameter
Default Value
iBMC management
network port
IP address and subnet
mask of the

Default IP address: 192.168.2.100

Default subnet mask: 255.255.255.0

Huawei N2000H V3 Specifications

General

Brand	Huawei
Model	N2000H V3
Category	Storage
Language	English