Huawei N2000H V3 - Logging in to the Remote Virtual Console

N2000H V3 Appliance
User Guide
9 Common Operations
Issue 04 (2018-11-06)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
252

The user name and password of the iBMC management network port.
The default user name of the iBMC is root, and the default password is Huawei12#$
Procedure
Logging In Through the SSH
The SSH protocol is used to provide the secure remote login and other network services on an
insecure network.
To log in to iBMC over SSH is secure by default. If the SSH service is disabled, enable the SSH service
on the Config > Port Settings page on the web user interface (WebUI) of iBMC.
To open the CLI over the SSH protocol in different OSs, perform the following operations:

In the Linux OS
a. Connect the network interface of the configuration terminal to the management
interface of the Appliance.
b. Run the ssh ipaddress command in the shell to log in directly.

In the Windows OS
a. Download and install the client communications tool that supports the SSH
protocol.
b. Connect the network interface of the configuration terminal to the management
interface of the Appliance.
c. Log in by using the user name, password, and IP address of the management
network interface.
Logging In Through the Telnet
To log in to iBMC over Telnet is insecure. By default, iBMC does not support Telnet login. If
you need to log in to iBMC over Telnet, enable the Telnet service on the Config > Port
Settings page on the web user interface (WebUI) of iBMC.
To open the CLI over the Telnet protocol in different OSs, perform the following operations:

In the Linux OS
a. Connect the network interface of the configuration terminal to the management
interface of the Appliance.
b. Run the telnet ipaddress command in the shell to log in directly.

In the Windows OS
a. Connect the network interface of the configuration terminal to the management
interface of the Appliance.
b. Run the telnet ipaddress command in the terminal tool to log in directly.
----End
9.4 Logging In to the Remote Virtual Console
This topic describes how to log in to the Appliance remote desktop over the iBMC WebUI.