Huawei N2000H V3 - Configuring RAID Properties

N2000H V3 Appliance
User Guide
4 Configuring the N2000H V3
Issue 04 (2018-11-06)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
72
Mainboard PCB: .C
------------------- NIC INFO -------------------
SM210 BoardID: 0x0014
SM210 PCB: .A
----------------Raid Card INFO -------------------
SR130 BoardID: 0x002C
SR130 PCB: .A
-------------- HDD Backplane INFO --------------
BC11THBK BoardID: 0x00cb
BC11THBK PCB: .A
BC11THBK CPLD Version: (U1011)1.05
BC11THBJ BoardID: 0x00ca
BC11THBJ PCB: .A
BC11THBJ CPLD Version: (U3)1.05
 CPLD Version: indicates the current complex programmable logical device
(CPLD) version of the N2000H V3.
 BIOS Version: indicates the basic input/output system (BIOS) version of the
N2000H V3.
 Active iBMC Version: indicates the active iBMC version of the N2000H V3.
 Backup iBMC Version: indicates the backup iBMC version of the N2000H
V3.
c. Query the health status for the N2000H V3.
iBMC / # ipmcget -d health
System in health state
 If the message "System in health state" is displayed, no further action is
required.
 If an alarm is generated, clear the alarm by referring to d to e.
d. Query alarms for the N2000H V3.
iBMC:/->ipmcget -d healthevents
System in health state
e. Clear alarms by referring to the HUAWEI Rack Appliance Alarm Handling (iBMC).
----End
4.3 Configuring RAID Properties
This topic describes how to configure RAID properties.
The procedure for configuring RAID properties varies according to the RAID controller card
type. For details about how to configure RAID properties, see the HUAWEI Appliance RAID
Controller Card User Guide.
The N2000H V3 supports the LSISAS2308, LSISAS3008, and LSISAS3108 RAID controller
cards. You can identify RAID controller card types using different methods.
Using the BIOS Boot Information

LSISAS2308 controller card
Press Ctrl-C to Start LSI Corp Configuration Utility... is displayed during the system
startup, as shown in Figure 4-5.