Huawei N2000H V3 - 3.1 Powering On; 4.3 Configuring RAID Properties

N2000H V3 Appliance
User Guide
3 Powering On and Off the N2000H V3
Issue 04 (2018-11-06)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
63
3 Powering On and Off the N2000H V3
About This Chapter
This topic describes the precautions and procedures for powering on and off the Appliance.
3.1 Powering On
This topic describes how to power on the Appliance.
3.2 Powering Off
This topic describes how to power off the Appliance.
3.1 Powering On
This topic describes how to power on the Appliance.
Scenarios

The Appliance is to be powered on after being properly installed.

The Appliance is to be powered on after being maintained.
Prerequisites
Conditions
The Appliance and internal components are properly installed.
Data

You have determined the rack number and installation position for the device to be
powered on.

You have obtained the IP address, user name, and user password for the management
network port on the iBMC.
Tools
Electrostatic discharge (ESD) wrist strap or ESD gloves: used to prevent ESD damage.
Documents