Huawei N2000H V3 - 2.4.4 Connecting a USB Device; 3 Powering On and Off the N2000 H V3

N2000H V3 Appliance
User Guide
2 Installing and Removing the N2000H V3
Issue 04 (2018-11-06)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
54
Power on the device, and ping the IP address of the peer device connected over the new cable.
If the peer device cannot be pinged, check that the cable is intact or the connector is securely
connected.
Step 7 Bind the new optical fiber.
Bind the new optical fiber using the same method as the old one. You can also remove all
cable ties and bind all optical fibers again if necessary.
----End
2.4.4 Connecting a USB Device
Scenarios

Use a USB keyboard and mouse to set parameters after logging in to the operating
system (OS).

Use a USB storage device, DVD-ROM drive, or floppy disk drive (FDD) to transmit
data or install an OS.
Prerequisites
Conditions

Confirm the Appliance installation position in the rack.

Obtain the USB device to be connected and place it near the Appliance.
Data
Check that data has been copied to the USB storage device to be connected.
Tools
Electrostatic discharge (ESD) wrist strap
Hardware
The USB storage device to be connected operates properly.
Procedure
Step 1 Connect the USB storage device to the USB port on the Appliance, as shown in Figure 2-23.