N2000H V3 Appliance
User Guide
3 Powering On and Off the N2000H V3
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
You have obtained the IP address, user name, and user password for the management
network port on the iBMC.
Tools
Electrostatic discharge (ESD) wrist strap or ESD gloves: used to prevent ESD damage.
Documents
For details about how to obtain the IP address for the management network port and how to
operate the iBMC, see the HUAWEI Rack Appliance iBMC User Guide.
Procedure
Power off the Appliance to have the Appliance enter the standby state.
Use the keyboard, mouse, and monitor to shut down the Appliance operating system
(OS).
Hold down the power button on the front panel until the Appliance is powered off.
Power off the Appliance by running commands for remote management.
On the iBMC CLI, run the ipmcset -d powerstate -v 0 command to power off the
Appliance remotely.
The iBMC WebUI is available.
After logging in to the iBMC WebUI, on the menu bar, choose Power, in the navigation
tree, choose Power Control, and choose Power Off > OK to power off the Appliance.
Power off the Appliance completely.
When the Appliance is in the standby state after it is powered off, remove the power cable to
disconnect the external power supply. After that, the Appliance powers off completely.
----End
To Next Page
Loading...
