Humidity and temperature sensor: The NetCol5000-C is able to deploy a maximum of
six humidity and temperature sensors to control the humidity and temperature in the data
center.
Intelligent Monitoring
You can monitor and configure the NetCol5000-C on network management terminals.
You can view the operating status and working mode of the NetCol5000-C on the
controller and modify current parameters and the control mode.
Quick Installation
The NetCol5000-C is preinstalled and assembled before delivery. You need only to perform
easy installation onsite, such as placing cabinets, adjusting leveling feet, combining cabinets,
and connecting chilled-water pipes, power cables, voltage jumpers, and communications
signal cables.
Easy Maintenance
Software maintenance: You can use controller USB ports to upgrade the NetCol5000-C,
perform maintenance, and set parameters. This reduces service costs.
Hardware maintenance: You can easily maintain the NetCol5000-C from both the front
and rear.
2.4 Components
The NetCol5000-C consists of cooling components, the controller, and monitoring system.
2.4.1 Cooling Components
Appearance
NetCol5000-C can be installed on a concrete floor or an ESD floor, is combined with IT
cabinets. It supports underfloor or overhead cabling and piping, and is maintained from the
front and rear doors without movement.
To Next Page
Loading...
