Huawei UPS5000-E Series - Page 159

UPS5000-E-(50 kVA-300 kVA)
User Manual (50 kVA Power Modules)
4 User Interface
Issue 11 (2019-12-20)
Copyright © Huawei Technologies Co., Ltd.
149
Item
Description
Default Value
Value Range
IP address
Specifies the IP address for the
Ethernet.
NOTICE
Ensure that the UPS IP address is
unique on the network segment.
Otherwise, the WebUI display
function may not function properly.
192.168.0.10
1.0.0.0–223.255.
255.255
Subnet mask
Specifies the subnet mask of the
Ethernet.
255.255.255.0
0.0.0.0–255.255.
255.255
Gateway
Specifies the Ethernet gateway.
192.168.0.1
1.0.0.0–223.255.
255.255
MAC address
Defines the physical address of
network equipment and is not
configurable.
-
-
NAT mapping
NAT means network address
translation. If it is set to Disable,
Internet cannot access IP
addresses in
t
he local area
network (LAN).
Disable
Disable, Enable
Figure 4-14 RS485 settings
Item
Description
Default Value
Value Range
Address
This serial port address is
allocated by the user.
1
1–254
Baud rate
Select a baud rate to match the
user's network management
conditions onsite.
9600
9600, 19200,
115200
Parity mode
Verify the validity of RS485
communication characters. When
a device node adopts RS485
None
None, Odd,
Even