2. Wiring
113
● Wiring Method
Connect the power supply to the enclosed connector
(Model code: MSTB2.5/6-STF-5.08: Phoenix Contact).
See below for how to lay out the power supply wires.
1) Loosen the terminal screw with using such as a slotted screwdriver to open up the inlet.
2) Reveal the sheath for 7mm on the cable that satisfies the cable diameter complies the
specification shown in the table below and put it in the inlet.
3) Tighten the terminal screw with using such as a slotted screwdriver. The inlet closes and affixes
the wire.
4) Connect all the wires in the same manner and insert the enclosed connector to the power
connector.
Power Supply Connector (PWR)
Pin No.
Signal Name
Contents Applicable cable diameter
1
L1
2
L2
Motor AC power input
2.0mm
2
(AWG14)
3
L1C
4
L2C
Control AC power input
0.75mm
2
(AWG18)
5
NC Unconnected
6
PE Protective ground line
2.0mm
2
(AWG14)
1) Loosen the screw
with a slotted screwdriver
2) Insert wire
Wire Inlet
3) Tighten the screw with
a slotted screwdriver
3) Plug in the enclosed connector to
the power connector on the
controller side
2.5.1
To Next Page
Loading...
