3. Operation
149
3.1.3 Parameter Settings
Parameter data should be set to be suit to the system or application. Parameters are variables
to be set to meet the use of the controller in the similar way as settings of the ringtone and
silent mode of a cell phone and settings of clocks and calendars.
(Example)
Soft Stroke Limit : Set a proper operation range for definition of the stroke end,
prevention of interferences with peripherals and safety.
Zone Output : Set to require signal outputs in an arbitral position zone within the
operation zone.
Parameters should be set to meet the use of the controller prior to operation. Once set, they
may not set every operation.
Refer to Chapter 8 for the parameter types and the details.
To Next Page
Loading...
Need help?
General
