3. Operation
244
3.3.5 Output Setting of Feeldback Pulse
This is a parameter to set when outputting the feedback pulse to the host controller (PLC, etc.).
This function is also available in Positioner Mode.
[1] Setting Feedback Pulse Output Effective
Set it if the feedback pulse is to be used.
No. Name Symbol Unit
Input
Range
Initial
Value
68 Feedback Pulse Output FPIO – 0 to 1 1
You can select whether to enable or disable the feedback pulse output.
0: Enable
1: Disable
Caution: Make this setting invalid if the feedback pulse is not output.
To Next Page
Loading...
Need help?
General
