8. Parameter
322
8.3 Servo Adjustment
The parameters are preset at the factory before shipment so that the actuator operates stably
within the rated (maximum) transportable weight.
However, the preset setting cannot always be the optimum load condition in the actual use. In
such cases, servo adjustment may be required.
This section describes the basic servo adjustment method.
Caution: Rapid and excessive settings are dangerous. They may devices including the
actuator to be damaged and/or people to be injured. Take sufficient note on
the setting.
Record settings during servo adjustment so that prior settings can always be
recovered.
When a problem arises and the solution cannot be found, please contact IAI.
To Next Page
Loading...
