To Next Page

To Previous Page

11. Select the OS Image to download. The XModem initiates the file transfer. When

the download is complete, a message similar to the following is displayed:

12. Select the image number to load the new image (1 or 2). It is recommended

that you select 1. A message similar to the following is displayed:

13. When you see the following message, change the Serial Port characteristics to

9600 bps:

14. Press the Escape key (<Esc>) to re-display the Boot Management menu.

15. Select 4 to exit and boot the new image.

yzModem - CRC mode, 27186(SOH)/0(STX)/0(CAN) packets, 6 retries

Extracting images ... Do *NOT* power cycle the switch.

**** Switch OS ****

Please choose the Switch OS Image to upgrade [1|2|n] :

Switch OS Image 1 ...

Un-Protected 27 sectors

Erasing Flash.............................. done

Writing to Flash..............................done

Protected 27 sectors

## Switch baudrate to 9600 bps and press ESC ...

Other manuals for IBM RackSwitch G8000

Questions and Answers:

Need help?

Do you have a question about the IBM RackSwitch G8000 and is the answer not in the manual?

General