Table 3-1 (Page 7 of 24). Firmware Error Codes.
Error Code Description Action / Possible Failing FRU
25A0xxx0 L2 Cache controller problem. 1. Replace the CPU card.
2. Replace the System board.
See error code 2B2xxx22 for xxx
definitions.
25A0xxx1 L2 Cache controller problem. 1. Replace the CPU card.
2. Replace the System board.
See error code 2B2xxx22 for xxx
definitions.
25A1xxx1 L2 SRAM failure Replace the CPU card.
See error code 2B2xxx22 for xxx
definitions.
25A80xxx NVRAM problems NVRAM problem resolution:
1. Errors reported against NVRAM
can be caused by low Battery
voltage and (more rarely) power
outages that occur during normal
system usage. With the exception
of the 25A80000 error, these errors
are warnings that the NVRAM data
content had to be re-established
and do not require any FRU
replacement unless the error is
persistent. When one of these
errors occurs, any system
customization (eg. boot device list)
information has been lost, the
system may need to be
re-configured.
2. If the error is persistent, replace
the battery.
3. If the error is persistent after
battery replacement, or the error
code is 25A80000, replace the I/O
board. (See notes on 3-1.)
25A80000 Initialization failed, device test failed. Refer to Action under error code
25A80xxx.
25A80001 Init-nvram invoked, ALL of NVRAM
initialized.
Refer to Action under error code
25A80xxx.
25A80002 Init-nvram invoked, some data
partitions may have been preserved.
Refer to Action under error code
25A80xxx.
25A80011 Data corruption detected, ALL of
NVRAM initialized.
Refer to Action under error code
25A80xxx.
25A80012 Data corruption detected, some data
partitions may have been preserved.
Refer to Action under error code
25A80xxx.
3-8 Service Guide
To Next Page
Loading...
Need help?
General