Table 3-1 (Page 12 of 24). Firmware Error Codes.
Error Code Description Action / Possible Failing FRU
2BA00012 Service processor reports self-test
failure.
1. Unplug the system power cable
and wait until the system power
indicator remains off and the
operator panel is blank.
2. Plug the system power cable back
in and retry the operation.
3. Replace the service processor
card.
4. Replace the I/O board. (See notes
on 3-1.)
2BA00013 Service processor reports bad NVRAM
CRC.
1. If problem persists, replace battery.
2. Replace the I/O board. (See notes
on 3-1.)
2BA00014 Service processor reports bad service
processor firmware.
Use service processor firmware
diskette to re-program firmware.
2BA00017 Service processor reports bad or low
battery.
1. Replace the battery.
2. Replace the service processor
card.
3. Replace the I/O board. (See notes
on 3-1.)
2BA00018 EPOW test failure. 1. Replace the service processor.
2. Replace the I/O board. (See notes
on 3-1.)
2BA00019 IRQ13 test failure. 1. Replace the I/O board. (See notes
on 3-1.)
2. Replace the service processor
card.
2BA00024 Service processor reports bad Power
Controller firmware.
Use the System Firmware diskette to
re-program the System firmware.
2BA00040 Service processor reports Service
Processor VPD module not present.
1. Use the Service Processor
Firmware diskette to re-program
the Service Processor firmware.
2. Replace the Service Processor
card.
2BA00041 Service processor VPD is corrupted. 1. Use the service processor firmware
diskette to re-program the service
processor firmware.
2. Replace the service processor
card.
2BA00050 Service processor reports system
operator panel VPD module not present
or not recognizeable.
Replace the operator panel control
assembly. (See notes on 3-1.)
Note: Swap the old VPD module from
the old operator panel control assembly
to the new one.
Chapter 3. Error Code to FRU Index 3-13
To Next Page
Loading...
Need help?
General