Cover release
latch
Top cover
Replacing the server top cover
This information provides instructions on how to replace the server top cover.
About this task
To install the server cover, complete the following steps:
Procedure
1. Make sure that all cables, adapters, and other components are installed and
seated correctly and that you have not left loose tools or parts inside the server.
Also, make sure that all internal cables are correctly routed.
2. Align the cover over the server (toward the rear of the server) until the cover
edges slip into position over the chassis.
Chapter 6. Removing and replacing components 227
To Next Page
Loading...
Need help?
General