Tabs
Tabs
Bezel
Bezel
screws
5. Pull the top of the bezel out slightly; then, rotate it downward until the tabs on
the bottom of the bezel disengages from the chassis and set it aside.
Replacing the bezel
This information provides instructions on how to replace the bezel.
About this task
To install the bezel, complete the following steps:
Procedure
1. Insert the tabs on the bottom of the bezel into the holes on the chassis.
2. Rotate the bezel upward to the server and reinstall the bezel screws.
Tabs
Tabs
Bezel
Bezel
screws
3. Install the cover (see “Replacing the server top cover” on page 227).
4. Reconnect the power cords and any cables that you removed.
5. Slide the server into the rack.
6. Turn on the peripheral devices and the server.
Chapter 6. Removing and replacing components 229
To Next Page
Loading...
Need help?
General