PCI riser-card assembly
(full height, half-length)
7. Remove the adapter, if necessary, from the PCI riser-card assembly.
8. Set the adapter and PCI riser-card assembly aside.
Replacing a PCI riser-card assembly
This information provides instructions on how to replace a PCI riser-card assembly.
About this task
To replace a PCI riser-card assembly, complete the following steps:
Procedure
1. Read the safety information that begins on page “Safety” on page vii and the
“Installation guidelines” on page 35.
2. Install the adapter in the new PCI riser-card assembly (see “Replacing an
adapter” on page 235).
3. Align the PCI riser-card assembly with the PCI slot connector on the system
board and align it with the slot on the chassis; then, lower it into the server
and press down firmly until the PCI riser-card assembly is seated correctly in
the connector on the system board.
284 System x3750 M4 Types 8722 and 8733: Installation and Service Guide
To Next Page
Loading...
Need help?
General