PCI
riser
slot
PCI riser-card assembly
(full height, half-length)
Riser-
card
filler
4. Reconnect the any cables that you disconnected earlier to the adapters.
5. Install the cover (see “Replacing the server top cover” on page 227).
6. Slide the server into the rack, if it was in a rack.
7. Reconnect the power cords and any cables that you removed.
8. Turn on the peripheral devices and the server.
Removing the operator information panel assembly
This information provides instructions on how to remove the operator information
panel assembly.
About this task
To remove the operator information panel, complete the following steps.
Procedure
1. Read the safety information and installation guidelines, see “Safety” on page vii
and “Installation guidelines” on page 35.
2. Turn off the server (see “Turning off the server” on page 22) and all attached
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
3. Slide the server out of the rack.
4. Remove the server cover (see “Removing the server top cover” on page 226).
5. Disconnect the cable from the rear of the operator information panel assembly.
6. Lift the two release tabs on the rear of the operator information panel and
carefully slide the assembly out of the front of the server.
Chapter 6. Removing and replacing components 285
To Next Page
Loading...
Need help?
General