Replacing the microprocessor air baffle
This information provides instructions on how to replace the microprocessor air
baffle.
About this task
To install the microprocessor air baffle, complete the following steps:
Procedure
1. Read the safety information that begins on page “Safety” on page vii and
“Installation guidelines” on page 35.
2. Align the tabs air baffle behind the latches (front and rear latches) of the two
DIMMs closest to the microprocessor (DIMM on the left and DIMM on the
right of the microprocessor); then, lower the air baffle down until it is seated
firmly.
Note: The microprocessor air baffle is only required when there are no DIMMs
in the connectors adjacent (on the left and the right) to the microprocessor.
Microprocessor
air baffle
3. Reinstall the cover (see “Replacing the server top cover” on page 227).
4. Slide the server into the rack.
5. Reconnect the power cords and any cables that you removed.
6. Turn on the peripheral devices and the server.
Chapter 6. Removing and replacing components 231
To Next Page
Loading...
Need help?
General