Replacing the CD/DVD cable
This information provides instructions on how to replace the CD/DVD cable.
About this task
To install the CD/DVD cable, complete the following cable:
Procedure
1. Read the safety information that begins on page “Safety” on page vii and
“Installation guidelines” on page 35.
2. Align the cable connector with the connector on the rear of the optical drive
and push the cable connector into the optical drive connector until it is firmly
seated.
3. Slide the cable connector to the right to lock the cable in place.
4. Connect the other end of the CD/DVD drive cable to the system board.
244 System x3750 M4 Types 8722 and 8733: Installation and Service Guide
To Next Page
Loading...
Need help?
General