Operator information
panel
3. Reconnect the cable to the rear of the operator information panel assembly.
Note: Make sure that cable is installed correctly by using the keys on the
connector and the keys on the cable. Incorrect installation of the cable can
damage the operator information panel.
4. Install the cover (see “Replacing the server top cover” on page 227).
5. Slide the server into the rack.
6. Reconnect the power cords and any cables that you removed.
7. Turn on the peripheral devices and the server.
Removing and replacing Tier 2 CRUs
This information provides instructions for removing and replacing tier 2 CRUs.
You may install a Tier 2 CRU yourself or request IBM to install it, at no additional
charge, under the type of warranty service that is designated for your server.
The illustrations in this document might differ slightly from your hardware.
Chapter 6. Removing and replacing components 287
To Next Page
Loading...
Need help?
General