the light path diagnostics panel on the operator information panel is also lit to
help isolate the error. This LED is controlled by the IMM.
Light path diagnostics
This information provides an introduction to the server light path diagnostics
feature.
The light path diagnostics LEDs are on the top of the operator information panel.
For additional information about light path diagnostics and LEDs, see “Light path
diagnostics” on page 170 and “Light path diagnostics LEDs” on page 174.
Note: The system service label on the underside of the cover also provides
information about the location of the light path diagnostics LEDs.
To access the light path diagnostics LEDs, press the blue release button on the
operator information panel and pull forward on the unit until the hinge of the
operator panel is free of the server chassis. Then pull down on the unit so that you
can view the light path diagnostics LEDs.
Release
button
Light path
diagnostic
LEDs
Operator information
panel
The following illustration shows the LEDs and controls on the light path
diagnostics panel.
Light Path Diagnostics
Chapter 1. The System x3750 M4 Types 8722 and 8733 server 19
To Next Page
Loading...
Need help?
General