Removing the DIMM air baffle
This information provides instructions on how to remove the DIMM air baffle.
About this task
To remove the DIMM air baffle, complete the following steps:
Procedure
1. Read the safety information and installation guidelines, see “Safety” on page vii
and “Installation guidelines” on page 35.
2. Turn off the server (see “Turning off the server” on page 22) and all attached
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
3. Remove the top cover (see “Removing the server top cover” on page 226).
4. Lift the DIMM air baffle from the server.
DIMM air baffle
Attention: For proper cooling and airflow, replace the air baffle before you
turn on the server. Operating the server with an air baffle removed might
damage server components.
232 System x3750 M4 Types 8722 and 8733: Installation and Service Guide
To Next Page
Loading...
