b. Grasp the handle and pull the drive out of the drive bay.
c. Skip to step 4.
3. Removing a 1.8-inch hot-swap drive:
a. Remove the filler panel.
b. Grasp the orange release latch on the drive tray handle of the drive tray for
the drive that you want to remove and slide the release latch down to
unlock the drive-tray handle; then, rotate the drive tray handle down and
the pull the handle toward you to slide the drive out of the bay. Lift the
drive out of the drive tray.
1.8-inch
filler panel
Release
latch
Drive tray
handle
4. If you are instructed to return the drive assembly, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Chapter 6. Removing and replacing components 237
To Next Page
Loading...
