Attention: Some cluster solutions require specific code levels or coordinated code
updates. If the device is part of a cluster solution, verify that the latest level of
code is supported for the cluster solution before you update the code.
To install the adapter, complete the following steps:
Procedure
1. Read the safety information that begins on page “Safety” on page vii and
“Installation guidelines” on page 35.
2. Touch the static-protective package that contains the new 6Gb host bus adapter
to any unpainted surface on the outside of the server; then, grasp the adapter
by the top edge or upper corners of the adapter and remove it from the
package.
3. Install the adapter on system board.
a. Align the adapter so that the keys align correctly with the connector on the
system board.
b. Insert the adapter into the connector on the system board until it is firmly
seated.
Attention: Make sure that the adapter is seated correctly. Incomplete
insertion might cause damage to the system board or the adapter.
c. Close the PCIe retention latch.
d. Reconnect the cables to the adapter.
e. Go to step 5 on page 259.
4. Install the adapter on the PCIe riser-card assembly.
a. Align the adapter so that the keys align correctly with the connector on the
riser-card assembly.
b. Insert the adapter into the connector on the riser-card until it is firmly
seated.
Attention: Make sure that the adapter is seated correctly. Incomplete
insertion might cause damage to the system board, the adapter, and the
PCIe riser card assembly.
c. Close the PCIe retention latch.
d. Reinstall the riser-card assembly onto the system board.
e. Reconnect the cables to the adapter.
258 System x3750 M4 Types 8722 and 8733: Installation and Service Guide
To Next Page
Loading...
Need help?
General