EasyManua.ls Logo

Icom IC-R30 - Power Supply

Icom IC-R30
183 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1
POWER SUPPLY
1-10
D About the safety use of the battery case
When installing batteries, make sure they are all the same brand, type and capacity.
Also, do not mix new and old batteries together.
• Keep the battery terminals clean. It’s a good idea to occasionally clean them.
Never incinerate used battery cells since the internal battery gas may cause them to
rupture.
Never expose a detached battery case to water. If the battery case gets wet, be sure to
wipe it dry before using it.
• Never use batteries whose insulated covering is damaged.
CAUTION: Install only alkaline batteries into the BP-293.
NOTE:
Remove the alkaline batteries when battery case is not used.
Do not connect a USB cable while the battery case is attached to the receiver.
The operation while connecting a USB is not guaranteed.
TIP:
The BP-293 meets IPX4 requirements for waterproof protection, only when it is
attached to the IC-R30.
The batteries may seem to have low capacity when used in low temperatures. Keep
the case warm in low temperature environments.

Table of Contents

Other manuals for Icom IC-R30

Related product manuals