Icom IC-R30 - D Partial Reset; Resetting

7
OTHER FUNCTIONS
7-19
■ Resetting
Occasionally, erroneous information may be displayed. This may be caused by static
electricity or by other factors.
If this problem occurs, turn OFF the receiver. After waiting a few seconds, then turn it ON
again. If the problem still exists, perform a Partial reset, as described below.
If the problem still exists after a Partial reset, perform an All reset.
The resets affect the following:
Partial reset
Settings on the MENU screen, receive history log, operating settings in
the VFO mode will be reset to their default values.
All reset
Settings on the MENU screen, receive history log, operating settings in
the VFO mode, Memory channel contents, Programmable Scan edges
and GPS memories will be reset to their default values.
NOTE: Before do a reset, make a backup of your setting data so you can reload it after the
reset.
D Partial reset
A Partial reset resets operating settings to their default values.
L The following settings are not returned to their default values.
• Memory channels
• Programmable Scan edges
• GPS memories
[MENU] > Others > Reset > Partial Reset
1. Push [MENU].
2. Select “Partial Reset” in the “Others” menu.
(Rotate [DIAL] to select it, and then push [ENTER].)
• A conrmation dialog appears.
3. Select “YES,” then push [ENTER].
• After resetting, the IC-R30 will automatically restart.