Icom IC-R30 - D Write to the Selected Channel

4
MEMORY OPERATION
4-7
■ Writing a memory channel (Continued)
D Write to the Selected Channel
The selected channel is overwritten.
Example: Writing 145.000 MHz to channel 08 in group 00.
1. Push [VFO/MR] to select the Memory mode.
2. Rotate [DIAL] to select the channel to be written.
3. Push [VFO/MR] to select the VFO mode.
4. Rotate [DIAL] to set the frequency and receive mode.
5. Push [MW].
6. Select “Write to Selected CH.”
(Rotate [DIAL] to select it, and then push [ENTER].)
• The selected Memory channel blinks.
L You can change the channel to be written, by rotating [DIAL].
7. Push [MW].
• A conrmation dialog appears.
8. Select “Yes.”
• Beeps sound and the memory channel is written, then returns to the VFO mode.
Target Memory channel
Set the frequency
(In the VFO mode)