Icom IC-R30 - Page 158

7
OTHER FUNCTIONS
7-47
•
dPMR RX ID
Command: 20 0801, 20 0802
u
~
!0q
,
w !1
,
!2e
~
y
• • • • • •
0 X 0 XX XX X X X
0 XX X X X
0 (Fixed)
q
Header flag data (First byte)
Data Description
bit7 0 (Fixed) —
bit6 0 (Reserved)
bit5 0 (Reserved)
bit4 0/1 0=dPMR446, 1=Tier2
bit3
See the table below Type of call
bit2
bit1 0/1 0=Scramble OFF, 1=Scramble ON
bit0 0 (Reserved)
Data
Description
bit3 bit2
1 1 All call
1 0 (Not used)
0 1 Individual or Group call
0 0 Not identified
w
Header flag data (Second byte)
Data Description
bit7 0 (Fixed) —
bit6 0 (Reserved)
bit5 0 (Reserved)
bit4 0 (Reserved)
bit3
0
(Reserved)
bit2
0
(Reserved)
bit1 0 (Reserved)
bit0 0 (Reserved)
e
~
y
: ID of the CALLER station (7 digits in decimal)
u
~
!0
: ID of the CALLED station (7 digits in decimal*)
!1
~
!2
: CC/COM ID (2 or 3 digits in decimal)
* If a wildcard is contained, corresponding digit is lled with “A.”
L If the CC/COM ID, CALLER or CALLED station is not identied, “FF” is returned.
L FF: No signal has been received since the power was turned ON.
■ CI-V information
D Commands (Continued)