Icom IC-R30 - Page 5

iv
Entering and editing text
Character type Selectable characters and symbols
AB
A to Z, 0 to 9, (space)
ab
a to z, 0 to 9, (space)
12
0 to 9, (space)
!”#
! " # $ % & ’ ( ) * + , - . / : ; < = > ? @
[ \ ] ^ _ ` { | } ˜ (space)
Selects a character
Selects
a character
Selects
a character
Clears
the entry
Moves the cursor
to the left
Opens the Entry Mode Select window
Selects
a character*
Keaypad
*Only when the DIAL/VOL Switch function is ON.
Alphabet
(Upper case)
Alphabet
(Lower case)
Number
Sets the entry
To enter characters
• To insert a text, move the cursor to a place to enter, then push the keypad.
L You can elect a character by rotating [DIAL], or pushing D-pad (Up) or D-pad (Down).
• When the character type is “AB” or “ab,” and while entering a character, push [QUICK] to
select upper case or lower case letters.
• To clear a character, push [CLEAR].
• To consecutively clear characters, continuously hold down [CLEAR].
INTRODUCTION
The usable characters are alphabets, numbers and symbols.
Moves the cursor
to the right
Entry Mode Select window