Icom ID-4100A

5
GPS OPERATION
5-32
D Setting the GPS alarm
A GPS alarm can sound when a target location comes
into the alarm area.
This function can be set to the caller station, all GPS
Memory channels, a specied Memory group or a
specied Memory channel.
0.25’ 0.25’
0.25’0.25’
N
Your
location
Your
location
Extended range
( Approximate 1 km,
1094 Y)
Limited range
( Approximate 500 m,
547 Y)
Beeps one times
Beeps three times
Beeps three times
When all channels or group is selected:
Alarm area 1 (Setting plural stations)
When a specied memory is selected:
Alarm area 2 (Setting specic station)
Point A
Point B
Point C
Example: Set the alarm to all GPS memory (All
Memories).
GPS > GPS Alarm
1. Push [MENU].
2. Rotate [DIAL] to select “GPS,” then push [ï].
3. Select “GPS Alarm,” then push [ï].
• Displays the GPS ALARM screen.
4. Select
“Alarm Select,” then push [ï].
5. Select “Group,” then push [ï].
6. Select “All Memories,” then push [ï].
• Returns to the GPS ALARM screen.
L If you want to set the alarm to a GPS memory group,
select“(No Group)” or “A” to “Z.”
7. Push [MENU].
• Returns to the standby screen, then displays “ì.”
L When either one of the stations in a specied group
enters the set range, the alarm sounds three times,
“GPS ALARM” pops up on the screen, and “ì”
blinks.
L To cancel the GPS alarm, select “OFF” in the step 5.
TIP: When “All Memories”, “A” to “Z” or “(No Group)”
is selected, the alarm sounds depending on the
“Alarm Area (Group)” setting on the MENU screen.
(GPS > GPS Alarm > Alarm Area (Group))
Adding or editing GPS memory (Continued)
Alarm sounds, and “GPS ALARM”
pops up.
Blinks
When the GPS alarm sounds
Previous view