Icom ID-4100A

1
MEMORY OPERATION
1-6
D Overwriting to the selected channel
You can write a frequency into a pre-entered channel.
Example: Writing 147.030 MHz into Memory channel
“018.”
1. Push [V/M] several times until you enter the
Memory mode.
2. Rotate [DIAL] to select the channel 18.
Destination channel
3. Push [V/M] to enter the VFO mode.
4. Rotate [DIAL] to set 147.030 MHz.
5. Push [MW].
6. Rotate [DIAL] to select “Write to Selected CH,”
then push [ï].
7. Push [MW].
• The conrmation dialog “Overwrite?” is displayed.
8. Select <YES>, then push [ï].
• Beeps sound, and writes into the selected Memory
channel.
• Returns to the standby screen (VFO mode).
Writing to a Memory channel (Continued)
D Copying Memory content to the VFO
It is convenient when you want to operate on a
channel frequency near a Memory or Call channel.
Example: Copying Memory channel “001” to the VFO.
1. Push [V/M] several times until you enter the
Memory mode.
2. Rotate [DIAL] to select the channel 1.
3. Push [MW].
4. Rotate [DIAL] to select “Copy to VFO,” then push
[ï].
• The conrmation dialog “Copy to VFO?” is displayed.
5. Select <YES>, then push [ï].
• Beeps sound, and copies the selected Memory
content to the VFO.
• Returns to the standby screen (VFO mode).
[DIAL]
[ ]
[V/M] [MW]
Previous view