Icom ID-4100A

1
MEMORY OPERATION
1-5
After setting a frequency in the VFO mode, you can
write it to a selected channel or an automatically
selected blank channel.
Memory channels 002 to 999 are blank as the default.
D Writing to the selected channel
Example: Writing 146.030 MHz into Memory channel 18.
1. Push [V/M] several times until you enter the VFO
mode.
2. Rotate [DIAL] to select 146.030 MHz.
3. Push [MW].
4. Rotate [DIAL] to select “Write to New CH.”
5. Rotate [DIAL] to select the Memory channel “018.”
L If you select a pre-entered channel, the previous
channel content will be overwritten.
L The Call channels are also selectable.
6. Push [MW].
• The conrmation dialog “Write to a blank channel?” is
displayed.
7. Select <YES>, then push [ï].
• Beeps sound, and writes into the selected Memory
channel.
• Returns to the standby screen (VFO mode).
D Writing to a blank channel
Example: Writing 146.030 MHz into a blank channel.
1. Push [V/M] several times until you enter the VFO
mode.
2. Rotate [DIAL] to set 146.030 MHz.
3. Hold down [MW] for 1 second.
• Beeps sound, and automatically writes into a blank
channel.
• Returns to the standby screen (VFO mode).
Writing to a Memory channel
[DIAL]
[ ]
[V/M] [MW]
Previous view