Icom ID-4100A

12
Bluetooth
®
OPERATION
12-12
Before connecting to an iOS device, you must pair
with it.
• How to pair (see below)
L See page 12-13 to connect to the paired device.
D Pairing with an iOS™ device
NOTE: Depending on the device, you may not be
able to pair with the Bluetooth device.
Step 1. Starting the RS-MS1I (iOS device)
1. Turn ON Bluetooth with your iOS device.
L See the instruction manual of the iOS device for
details.
2. Tap the RS-MS1I icon to start.
L See page 12-9 for details on downloading the RS-MS1A.
RS-MS1I icon
• Displays the pairing device list.
Step 2. Entering the pairing reception mode
(Transceiver)
Bluetooth Set > <<Pairing Reception>>
1. Push [MENU].
2. Rotate [DIAL] to select “Bluetooth Set,” then push [ï].
3. Select “<<Pairing Reception>>,” then push [ï].
Turn ON Bluetooth with your iOS device within the
displayed period of time. When the time runs out,
the transceiver exits the Pairing reception mode.
Step 3. Sending a pairing request to the
transceiver (iOS device)
1. On the RS-MS1I, tap “Scan.”
• The device displays the UT-137 Bluetooth
®
unit name.
L You can conrm the UT-137’s name on the
BLUETOOTH DEVICE INFORMATION screen.
(Default: ICOM BT-003) (p. 9-72)
2. Tap the displayed UT-137’s name to send a
pairing request.
• The iOS device starts to send a pairing request.
L When your call sign has not been entered in the
transceiver, you should enter in before you connect.
L After the connection has succeeded, the iOS device
displays “Bluetooth connected to ICOM BT-003.”
Connecting to an iOS™ device
L About the transceiver’s display
After the connection has succeeded, the transceiver
displays “MMM Connected.” and the Bluetooth icon
is displayed.
(“MMM” is the Bluetooth name of the iOS device.)
Displayed
On the PAIRING/CONNECT screen, “ ” is displayed
to the left of the iOS device name.
(Bluetooth Set > Pairing/Connect)
Data device icon
Device name
Displayed while connecting
NOTE: Before connecting, check the following items
are correctly set.
• Set “CI-V Transceive” to “ON.”
(Function > CI-V > CI-V Transceive)
• Set “Serialport Function” to “CI-V (Echo Back OFF).”
( Bluetooth Set > Data Device Set > Serialport Function)
• Set the same CI-V address between the transceiver
and the RS-MS1I.
Transceiver:
“CI-V Address” in the MENU screen
(Function > CI-V > CI-V Address) (Default: 9A)
RS-MS1I:
“Application Setting”  “CI-V address”
(Default: Transceiver[9A])
Previous view